Please select a shopping list

Flat clamp joint set

Flat clamp joint set steel bk

In stock

The HJ-15 is a metal connector that allows you to connect a pipe with a surface. This connector is a prime choice if you need to secure the surface solidly onto your Flexpipe structure. If you want to create multiple anchor and support points, this connector is the best solution in the Flexpipe system. Unlike other clamping solutions in the system, this one will create the most uniform look of all.

This joint eliminates the need to use EMT-1 and the AO-SHIM that goes with it. This is possible because the Connector itself acts as a shim. This solution creates a stronger bond between the pipe and the surface. To assemble an HJ-15, you need to group an H-15 and an H-16 with one M6-12B bolt and one M6-N nut.

The HJ-15 is the only joint in the Flexpipe system that doesn’t use a standard connector bolt. Make sure you have selected the right bolt when purchasing the parts necessary to assemble this metal joint. The right Bolt for this joint is the M6-12B, which requires an M6-N.
More Information
Best SellerNo
Units per boxNA
Needed parts1 (H15) + 1 (H16) + 1 (M6-12B)
External height inches1 5/16 in (33mm)
External width inches2 5/8 in (67mm)
External depth inches1 5/16 in (33mm)
Unit weight pounds0.200 lbs (0.091 kg)
RoHS certificationYes
Frequency of useModerate
Reusable partsYes
Electric conductivity (ESD)No
MaterialHot rolled steel (SPHC)
Steel hardness (HRB)0.65
UV resistanceHigh
System operational temperature-40°F à 122°F (-40°C à 50°C)
Steel treatmentBlack cathodic electrodeposition (Ecoating)
Striations for grip4
Additional reinforcement hole2
1- Make sure you have the following parts:
1 H-15
1 H-16
1 M6-12B
1 M6-N
1 28mm pipes of your choice
1 Allen key or one drill equipped with an Allen Key 5mm tip
2-Take a connector H-15 and a connector H-16 and group them around the P1 pipe. 3-Take a M6-12B bolt and a M6-N nut and insert them into the corresponding openings. Make sure to put the bolt on the more accessible side.
4- Tighten completely the M6-12B bolt and M6-N nut together until the HJ-15 attached firmly to the P1 pipe. A force of 9.8 Nm is recommended for this step.
5- Fix the HJ-15 on the surface of your choice with a F-C61 or one appropriate screw for the select surface.