Please select a shopping list
SKU
HJ-24NP

Cross Hinge Joint Set Steel - ESD

3 way cross hinge joint set chrome plated steel
CDN$3.85

In stock

  • Compatible with 28 mm pipes
  • Nuts and bolts are included, but packaged separately
  • Assembly required
  • Joint set with antistatic properties (ESD)

The HJ-24NP is a chrome-plated joint set with antistatic properties (ESD) that allows you to create a swivel three-pipe intersection on two axes.

To assemble an HJ-24NP you need to combine two H-24NP, an AP-HINGE hinge bracket, two M6-25BWZ bolts and two M6-NWZ nuts.

Technical Information:
This joint set is designed with 8 striations for a better grip on the plastic coating of the 28 mm pipes.

Assembly tip:
If your structure doesn't require a swivel joint, we recommend that you use the HJ-4NP, because it will not weaken your structure's capacity. This joint set is very similar to the HJ-24NP with the only difference that is doesn't have a hinge bracket.

Installation Steps:
See the installation steps tab to view how to assemble this connector.

Non-Electric Conductivity Version:
A version of this joint set is offered without antistatic properties: HJ-24

Want to reuse parts of your old system?
The HJ-24NP Flexpipe joint set is compatible with many other pipe and connector systems. Check the technical information tab to know which systems are compatible and none-compatible with our parts.

Please note that nuts and bolts are included, but packaged separately. Assembly is required.

More Information
Length5 1/8 in (130 mm)
Height1 5/16 in (33 mm)
Width1 5/16 in (33 mm)
Material Thickness1/8 in (2.5 mm)
Weight0.502 lb (0.228 kg)
Compatible brandCreform, Fastube, Trilogiq (28 mm), NIS (28 mm), C Tek Lean Solutions (28 mm)
Non Compatible BrandTrilogiq (28.6 mm)
Primary MaterialHot rolled steel (SPHC) with chrome plating
Secondary MaterialPolyethylene (PE)
Temperature Resistance-148°F to 572°F (-100°C to 300°C)
Electric Conductivity (ESD)Yes (10– 10^3)
Manufacturing TechniqueStamping and deburring
  1. Ensure you have the following parts:
  2. Press the AP-HINGE bracket on the first pipe until it clips on, place opening of the bracket inside of the pipe.
  3. Group the two H-24NP connectors around the first and the second pipe. Make sure that the AP-HINGE bracket teeth fit into the corresponding openings.
  4. Fix the connectors together by placing the M6-25BWZ bolt with the M6-NWZ nut in the corresponding openings, and loosely tighten. Make sure to place the bolts on the most accessible side.
  5. Insert the second and the third pipes in both of the remaining openings of the HJ-24NP, between the first and the second positionning guidelines.
  6. Tighten completely until the HJ-24NP joint set is firmly attached to the three pipes. A force between 12-14 Nm is recommended for this step.
  7. If the HJ-24NP feels too tight to rotate, apply a lubricant spary to ease the mobility of the AP-HINGE bracket and to avoid damaging the plastic teeth.

You need to enter info before adding a new review.

Write Your Own Review
You're reviewing:Cross Hinge Joint Set Steel - ESD