Side anchor joint set

Side anchor joint set steel bk

CDN$2.05

In stock

Skip to the beginning of the images gallery

Description

The HJ-8 is a metal anchor connector you can use to connect surfaces to Flexpipe structures. This joint is made to be secured on the border of surfaces and structures. This connector has the unique benefit of giving you the option of merging the Flexpipe system with non-Flexpipe furniture and other structures. Doing so could result in the creation of incredible hybrid architecture. We mostly use this at Flexpipe to mount workstation shelving onto Flexpipe creations.

To make an HJ-8, you need to assemble one H-8 and one H-9 together with one M6-25B bolt and one M6-N nut. This anchor can also serve as a securing support underneath the surface. However, we recommend that you check out our many other products that are better suited to accomplish that task. If you don't have a knack for installing Flexpipe structures, be sure to check the HJ-9 product page which could be the solution for this problem.

This connector will not be used as often than the HJ-9, because you always require an edge to install it. Nonetheless, the HJ-8 will be the joint of choice if you don't want to use too much space on your surface.

Technical Information

More Information
Best Seller	No
Units per box	NA
Needed parts	1 (H8) + 1 (H9) + 1 (M6-25B) + 1 (M6-N)
External height inches	3 3/4 in (95mm)
External width inches	2 in (51mm)
External depth inches	1 5/16 in (33mm)
Unit weight pounds	0.304 lbs (0.138 kg)
RoHS certification	Yes
Recyclable	Yes
Frequency of use	Very low
Reusable parts	Yes
Electric conductivity (ESD)	No
Material	Hot rolled steel (SPHC)
Steel hardness (HRB)	0.65
Finish	Glossy
UV resistance	High
System operational temperature	-40°F à 122°F (-40°C à 50°C)
Steel treatment	Black cathodic electrodeposition (Ecoating)
Striations for grip	4

Installation Steps

1- Make sure you have the following parts:
1 H-8
1 H-9
1 M6-25B
1 M6-N
1 28mm pipes of your choice
1 Allen key or one drill equippedwith an Allen Key with a 5mm tip
2-Take a connector H-8 and a connector H-9 and group them around the P1 pipe. 3-Take a M6-25B bolt and a M6-N nut and insert them into the corresponding openings. Make sure to put the bolt on the more accessible side.
4- Tighten completely the M6-25B bolt and M6-N nut together until the HJ-8 attached firmly to the P1 pipe. A force of 9.8 Nm is recommended for this step.
5- Fix the HJ-8 on the surface of your choice with six F-C61 or six appropriate screws for the desired surface.