Please select a shopping list
SKU
HJ-7NP

Intersection joint set

Intersection joint set steel cr
USD$1.45

In stock

The HJ-7NP is a metal anti-static connector set that allows you to connect two pipes perpendicularly, one above another. This joint is mainly used for building 2-level wire meshes, shelf supports, and for reinforcing wheels and structures after they are completed.

To make an HJ-7NP, you need to place two H-7NP together with one M6-25BWZ bolt and one M6-NWZ nut. The purpose of using this connector is mostly to reinforce your structures. Once installed, it doubles the structural strength of the two perpendicular pipes. The same result can be achieved for parallel pipes by using the HJ-13NP so be sure to check this one out if you want to reinforce parallel pipes. Unlike the HJ-4NP, this assembly can create a wire mesh without having to break the pipes and in a way where they don't lose structural capacity but rather gain some.

This connector is one of the easiest to assemble in all the Flexpipe system.
More Information
Best SellerNo
Units per boxNA
Needed parts2 (H7NP) + 1 (M6-25BWZ) + 1 (M6NWZ)
External height inches1 5/16 in (33mm)
External width inches3 in (76mm)
External depth inches1 5/16 in (33mm)
Unit weight pounds0.231 lbs (0.105 kg)
RoHS certificationYes
RecyclableYes
Frequency of useModerate
Reusable partsYes
Electric conductivity (ESD)Yes
MaterialHot rolled steel (SPHC)
Steel hardness (HRB)0.65
FinishGlossy
UV resistanceHigh
System operational temperature-40°F à 122°F (-40°C à 50°C)
Steel treatmentNickel electroplating
1- Make sure you have the following parts:
2 H-7NP
1 M6-25BWZ
1 M6-NWZ
2 28mm pipes of your choice
1 Allen key or one drill equipped with an Allen Key 5mm tip
2-Take two connectors H-7NP and group them around the P1 and P2 pipes. 3-Take a M6-25BWZ bolt and a M6-NWZ nut and insert them into the corresponding openings. Make sure to put the bolt on the more accessible side.
4- Tighten completely the M6-25BWZ bolt and M6-NWZ nut together until the HJ-7NP attached firmly to the two pipes . A force of 9.8 Nm is recommended for this step.