The HJ-90NP is a chrome-plated joint set with antistatic properties (ESD) that allows connecting two 28 mm pipes to create a 90-degree corner. This joint set is often used for ergonomic cart handles.
This joint set is designed with 8 striations for a better grip on the plastic coating of the 28 mm pipes. It also includes 4 additional pre-drilled reinforcement holes to ensure extra strength to your structure. By adding a self-drilling screw F-A85/8, you will solidify the connector joints positioned on a corner where there is a higher risk of impact.
See the installation steps tab to view how to assemble this connector.
Non-Electric Conductivity Version:
A version of this joint set is offered without antistatic properties: HJ-90
Want to reuse parts of your old system?
The HJ-90NP Flexpipe joint set is compatible with many other pipe and connector systems. Check the technical information tab to know which systems are compatible and none-compatible with our parts.
|Units per box||NA|
|Needed parts||2(H90NP) + 2 (M6-25BWZ) + 2 (M6NWZ)|
|Length inches||3 1/8 in (79 mm)|
|Width inches||1 5/16 in (33 mm)|
|External height inches||2 3/16 in (55mm)|
|External width inches||2 3/16 in (55mm)|
|External depth inches||1 5/16 in (33mm)|
|Steel thickness inches||1/8 in (2.5 mm)|
|Unit weight pounds||0.488 lbs (0.222 kg)|
|common uses||Handle corner|
|Compatible joint systems||Creform, NIS, C Tek Lean Solutions, Trilogiq (28 mm)|
|None compatible joint systems||Fastube, Trilogiq (28.6 mm)|
|Compatible pipe systems||Creform, Fastube, Trilogiq (28 mm), NIS (28 mm), C Tek Lean Solutions (28 mm)|
|None compatible pipe systems||Trilogiq (28.6 mm)|
|Frequency of use||High|
|Electric conductivity (ESD)||Yes|
|Material||Hot rolled steel (SPHC)|
|Steel hardness (HRB)||68-75 HRB|
|Corrosion resistance||240 hours salt spray corrosion test|
|System operational temperature||-148°F to 572°F (-100°C to 300°C)|
|Steel treatment||Chrome plating|
|Manufacturing technique||Stamping and deburring|
|Striations for grip||8 striation grip lines|
|Positioning guide||4 positioning guide lines|
|Additional reinforcement hole||4 reinforcement holes|
2- Take two connectors H-90NP and group them around the pipes P1 and P2.
3-Take two M6-25BWZ bolts and two M6-NWZ nuts and insert them into the corresponding openings. Make sure to put the bolt on the more accessible side.
4- Tighten completely the M6-25BWZ bolts and M6-NWZ nuts together until the H-90NP attached firmly to both pipes . A force of 9.8 Nm is recommended for this step.
Need more informations ?
Here's everything you need to know!