The HJ-7NP is a chrome-plated joint set with antistatic properties (ESD) that allows creating an intersection of two pipes, one above another. This joint set is mainly used to reinforce structures by building shelving supports, to strengthen the casters support, or to create a pipe grid, similar to a welded wire mesh.
Well used, this joint set can double the strength of the perpendicular tubes of your structure. This assembly can also create a grid of tubes, but unlike the HJ-4NP, it won't compromise your structure rigidity because no tubes required to be cut. The same result can be obtained for parallel tubes when using the HJ-13NP joint set.
See the installation steps tab to view how to assemble this connector.
Non-Electric Conductivity Version:
A version of this joint set is offered without antistatic properties: HJ-7
Want to reuse parts of your old system?
The HJ-7NP Flexpipe joint set is compatible with many other pipe and connector systems. Check the technical information tab to know which systems are compatible and none-compatible with our parts.
|Units per box||NA|
|Needed parts||2 (H7NP) + 1 (M6-25BWZ) + 1 (M6NWZ)|
|Length inches||2 7/8 in (73 mm)|
|Width inches||1 in (25 mm)|
|External height inches||1 5/16 in (33mm)|
|External width inches||3 in (76mm)|
|External depth inches||1 5/16 in (33mm)|
|Steel thickness inches||1/8 in (2.5 mm)|
|Unit weight pounds||0.231 lbs (0.105 kg)|
|Compatible joint systems||Creform, NIS, C Tek Lean Solutions, Trilogiq (28 mm)|
|None compatible joint systems||Fastube, Trilogiq (28.6 mm)|
|Compatible pipe systems||Creform, Fastube, Trilogiq (28 mm), NIS (28 mm), C Tek Lean Solutions (28 mm)|
|None compatible pipe systems||Trilogiq (28.6 mm)|
|Frequency of use||Moderate|
|Electric conductivity (ESD)||Yes|
|Material||Hot rolled steel (SPHC)|
|Steel hardness (HRB)||68-75 HRB|
|System operational temperature||-148°F to 572°F (-100°C to 300°C)|
|Steel treatment||Chrome plating|
|Manufacturing technique||Stamping and deburring|
|Striations for grip||None|
|Additional reinforcement hole||None|
2 28mm pipes of your choice
1 Allen key or one drill equipped with an Allen Key 5mm tip
2-Take two connectors H-7NP and group them around the P1 and P2 pipes. 3-Take a M6-25BWZ bolt and a M6-NWZ nut and insert them into the corresponding openings. Make sure to put the bolt on the more accessible side.
4- Tighten completely the M6-25BWZ bolt and M6-NWZ nut together until the HJ-7NP attached firmly to the two pipes . A force of 9.8 Nm is recommended for this step.
Need more informations ?
Here's everything you need to know!