English US
Français CA
Español US
English CA
Double pivot joint set
In stock
- Compatible with 28 mm pipes
- Nuts and bolts are included, but packaged separately
- Assembly required
The HJ-14 is a black metal joint set allows to create an intersection of three pipes with adjustable angle on each side of the cross tube.
To assemble an HJ-14 you need to put two H-14 with four H-6, four M6-25B bolts and four M6-N nuts. It is also possible to assemble the HJ-14 with four H-6A's.
Assembly tip:
This joint set is very similar to a doubled HJ-6. It is frequently used for reinforcing structures, or to create articulations and anchors. This joint set allows each side tube to rotate up to 175 degrees.
Technical Information:
This joint set is designed with 8 striations for a better grip on the plastic coating of the 28 mm pipes. These grips are found on the H-6 or H-6A.
Installation Steps:
See the installation steps tab to view how to assemble this connector.
Antistatic Version (ESD):
An electric conductivity version if offered if you wish to build antistatic structures: HJ-14NP
Want to reuse parts of your old system?
The HJ-14 Flexpipe joint set is compatible with many other pipe and connector systems. Check the technical information tab to know which systems are compatible and none-compatible with our parts.
Please note that nuts and bolts are included, but packaged separately. Assembly is required.
| Box Quantity | NA |
|---|---|
| Frequency of Use | Very low |
| Electric Conductivity (ESD) | No |
| Manufacturing Technique | Stamping and deburring |
- Ensure you have the following parts:
- Take two H-6 connectors and group them around the first pipe. Fix the connectors by placing an bolt and an nut in the corresponding openings until it's firmly attached to the pipe.
- Repeat step 1 with the second pipe.
- Group the two H-14 connectors around the third pipe, and insert the H-6 connectors attached on the first pipe in between the H-14 connectors through corresponding openings. Fix the connectors by placing the bolt with the nut in the corresponding openings and loosely tighten.
- Repeat step 3 with the second pipe on the opposite side of the H-14.
- Position the first and second pipes into desired angles and tighten completely until the H-14s are firmly attached to the H-6 connectors.
You need to enter info before adding a new review.
Products you may need
Need more informations ?
Here's everything you need to know!
