Please select a shopping list

Upper bracket for caster

Caster up bracket steel zinc
Farnham: 3852
Los Angeles: 1867
Lawrenceville: 6738
  • Used to install plate casters
  • Galavanized steel
  • Combine with WF-LOW

The WF-UP is a metal bracket used to secure plate casters in conjunction with the WF-LOW on Flexpipe structures, such as the W-4PSB and W-4PF.

WF-UP and the WF-LOW are installed with two M8-35B bolts and two M8-N nuts.

You can use this bracket to stabilize two pipes as an alternative to the HJ-13. Since the brackets are longer than the HJ-13, this could be a good option.

This accessory is not for six-inch casters. The larger version of this bracket should be chosen if this is what you need. So if you are using W-6PSB or W-6PF wheels be sure to use the WF-LARGE product page.

Antistatic (ESD):
Compatible with EP-96-ST and EP-96-BK

Installation Steps:
See the installation steps tab to view how to assemble the WF-UP.

Want to reuse parts of your old system?
The WF-UP is compatible with many other pipe and connector systems. Check the technical information tab to know which systems are compatible and none-compatible with our parts.

More Information
Box Quantity180
Length4 9/16 in (116 mm)
Height1/2 in (13 mm)
Width1 5/16 in (33 mm)
Weight0.180 lb (0.082 kg)
Box DimensionsCardboard box of 11 X 9 X 5 in (279 mm X 229 mm X 127 mm)
Common UsageUsed to install plate casters
Compatible brandFlexpipe, Creform, Fastube
Non Compatible BrandTrilogiq
Primary MaterialGalvanised hot rolled steel (SPHC)
Temperature Resistance-58°F to 185°F (-50°C to 85°C)
Electric Conductivity (ESD)Yes
Manufacturing TechniqueFolded
  1. Ensure you have the following parts:
    • 1x W-4PSB or W-PF
    • 2x WF-UP
    • 2x WF-LOW
    • 4x M8-35B
    • 4x M8-N
    • 2x 28mm pipes of your choice
    • 1x Wrench
    • 1x Ratchet
  2. Ensure that the structure is leveled when supported by the pipes that will be wheeled. Otherwise, the height difference might cause the structure to sway.
  3. Flip the structure for better access to the bottom pipes.
  4. Ensure the pipes are parallel and have 3 1/4 in of center spacing.
  5. Place the two WF-LOW perpendicular on the pipes.
  6. Place the caster on both WF-LOW and align the openings.
  7. Take one WF-UP and regroup it with one of the WF-LOW.
  8. Take two M8-35B bolts and two M8-N nuts and insert them into the corresponding openings. Then lightly tighten them together.
  9. Repeat steps 6 and 7 for the other WF-UP and the bolts and the nuts remaining.
  10. Tighten completely the four M8-35B bolts and the four M8-N nuts in a cross pattern.

You need to enter info before adding a new review.

Write Your Own Review
You're reviewing:Upper bracket for caster