Tee joint set
In stock
- Compatible with 28 mm pipes
- Nuts and bolts are included, but packaged separately
- Assembly required
- Joint set with antistatic properties (ESD)
The HJ-1NP is a chrome-plated joint set with antistatic properties (ESD). This piece allows you to connect two 28 mm pipes in a T-shape or to create a corner. You can rotate this connector up to 360-degree before fixing it to make 45- or 90-degree support for surfaces or just for supporting your products.
This joint set was designed for a quick and easy installation. This piece is the simplest to assemble and the most commonly used in the entire Flexpipe system. Applications for this connector are numerous; from corners to separations, pegs, 45-degree supports and supports for accessories like the AW-HOLDER. To assemble an HJ-1NP you need to put two H-1NP together with an M6-25BWZ bolt and an M6-NWZ nut. You should always keep a box of these three parts in inventory since they are going to be used in 95% of your Flexpipe structures.
Technical Information:
This joint set is designed with 8 striations for a better grip on the plastic coating of the 28 mm pipes. It also includes 4 additional pre-drilled reinforcement holes to ensure extra strength to your structure. By adding a self-drilling screw F-A85/8, you will solidify the connector joints positioned on a corner where there is a higher risk of impact.
Installation Steps
See the installation steps tab to view how to assemble this connector.
Non-Electric Conductivity Version:
A version of this joint set is offered without antistatic properties: HJ-1
Want to reuse parts of your old system?
The HJ-1NP Flexpipe joint set is compatible with many other pipe and connector systems. Check the technical information tab to know which systems are compatible and none-compatible with our parts.
Please note that nuts and bolts are included, but packaged separately. Assembly is required.
Frequency of Use | Very High |
---|---|
Electric Conductivity (ESD) | Yes |
Manufacturing Technique | Stamping and deburring |
- Ensure you have the following parts:
- Put the two H-1NP together around the first pipe.
- Loosely tighten the M6-25BWZ and the M6-NWZ by putting them in the corresponding opening of the HJ-1NP.
- Insert the second pipe between the two H-1NP at the opposite side of the joint, between the first and second guidelines.
- Tighten completely the M6-25BWZ and the M6-NWZ together until the HJ-1NP is firmly attached to the pipes.
Need more informations ?
Here's everything you need to know!